Recording A Cd By Specifying Tape Length (Time Edit) - Sony CDP-C365 Operating Instructions Manual

12
See ee
Recording a CD by Specifying
Tape Length (Time Edit)
You can have the player create a program that will fit
the length of the tape.
The player automatically creates a program, keeping
the original order of the disc.
The program can contain up to 32 tracks (a pause
inserted between tracks is counted as one track).
Note that tracks whose numbers are over 24 cannot be
programmed.
EDIT/TIME FADE
IkKK/bPI
DISC SKIP
1 Press DISC SKIP to select the disc.
2 Press EDIT/TIME FADE repeatedly before you
start playing until "EDIT" appears and "A" in the
(&s} indication flashes in the display.
3 Press IKI or PDA to specify the tape length.
Each time you press these buttons, the display
changes as shown below, with the tape length of
one side following each indication.
C-46 +> C-54 ++ C-60 «+ C-74 ++ C-90 +4 ----
(23.00) (27.00) (30.00) (37.00) (45.00)
4 Press EDIT/TIME FADE to have the player create
the program.
The display shows the tracks to be recorded. "B" in
the [a6] indication flashes in the display.
5 When you record on both sides of the tape, press
EDIT/TIME FADE again.
The player inserts a pause, then creates the
programme for side B. The display shows the
programmed tracks.
When you record on one side of the tape, skip this
step,
6 Start recording on the deck and then press > on
the player.
When you record on both sides of the tape, the
player pauses at the end of the program for side A.
7 When you record on side B, reverse the tape and
y' Pe
press [> or ill on the player to resume playing. —
To cancel time edit
Press CONTINUE.
¢ You can program the tracks you want in advance
Select the tracks before doing the above procedure. The
player creates a program from the remaining tracks.
¢ You can freely specify the tape length
Set the tape length using number buttons. To enter "0,"
use button 10.
Example: When the tape length of one side is 30 minutes
and 15 seconds
Press 3, 10, 1 and 5.
¢ You can check and change the program
See page 11.
ES See ee ee ee
Fading In or Out
You can manually fade in or out to prevent tracks from
starting or ending abruptly.
> KKX/P>>i
EDIT/TIME FADE
FADER
To Press FADER
Start play fading in During pause. The -#tl indication
flashes and play fades in.
End play fading out When you want to start fading out.
The 1 indication flashes. The play
fades out and the player pauses.
rr nian sin
Recording From CDs