Table of Contents
Advertisement
5520, 5525, & 5530 WARMING
CABINETS
5. Repair
DOOR HANDLE
À
SWING 180°
+
QXX
|
DOOR HANDLE RELOCATION
Remove
the #10-32
screw
and
trim
washer
located
in the
bottom
portion
of the
door,
directly below the door handle. Loosen the #10- |
24 screw that secures the door handle to the
door
panel
in the vicinity
of the door
latch.
Remove the other #10-24 screw that secures the
opposite
end
of the
door
handle.
Carefully
allow the door handle to swing downward and
reassemble the unattached end to the hole that
had previously held the #10-32 screw and trim
washer. Tighten
the fastener that secures the
other end
of the door
handle.
Assemble
the
#10-32 screw and trim washer to the hole that
had originally secured the door handle.
Rotate the door 180 degrees. Reassemble the
inside door panel and gasket to the door. Do not
rotate the panel and gasket.
Reassemble
the door to the hinges using the
hex head hinge pins. Assemble the lower hinge
pin first. Fit door onto the pin and align door
with the upper hinge. Assemble upper hinge pin
to secure door to Warming Cabinet.
Model 5530
If unit has an exterior cabinet, the cabinet
will have to be disassembled to allow the
door hinges to be moved.
nore >
£
UPPER
HINGE PIN
DOOR
o
pees
LOWER
HINGE
PIN
DOOR REMOVAL
With door held in the closed position, remove
the lower and upper hex head hinge pins, in that
order. Then remove the door.
Remove
the upper and lower hinge mounting
bracket assemblies. -
SCREWS
&TRIM こつ な
WASHERS
HINGE
MOUNTING
LATE
BRACKET
ASSEMBLY
ASSEMBLY
1
WASHER-
SCREWS
HERO
&TRIM
—el__
SWITCH
SE
e
WASHERS
b
Г
HINGE
MOUNTING
SWITCH
BRACKET
ASSEMBLY
DOOR HARDWARE RELOCATION
30926
29
Advertisement
Table of Contents
