MDT CASTLE 5520 Service Manual page 33

SCREWS 3
& TRIM
WASHERS
| HINGE
MOUNTING
SWITCH — BRACKET
=
k
STRIKER
se
i
PLATE "一 一 |
ASSEMBLY
Gi WASHER-
HEAD
SWITCH À SCREWS
E
SCREWS
& TRIM Е
WASHERS Е
HINGE
ll MOUNTING
SWITCH BRACKET
E ASSEMBLY
DOOR HARDWARE RELOCATION
3. Remove the two sets of screws, trim washers,
and stiffeners from the opposite side of the
Warming Cabinet, and assemble them in the
holes where the hinge mounting brackets had
previously been assembled. In turn, assemble
the hinge mounting brackets to the opposite
side of the Warming Cabinet.
4. Removethe door striker plate assembly from its
mounting position on the Warming Cabinet
side panel. Remove the three washer-head
screws from the identical mounting position on
the opposite Warming Cabinet side panel.
Reassemble the door striker plate assembly to
the holes where the three washer-head screws
had previously been located, and reassemble
the washer-head screws to the position pre-
viously occupied by the door striker plate
assembly.
DOOR А
SELF-TAPPING
SCREW
INSIDE PANEL ss
& GASKET
PANEL & GASKET REMOVAL
ROTATE 180°
NAMEPLATE
DOOR
SPEED CLIP
NAMEPLATE ROTATION
6. Remove the nameplate. It is secured with two
speed clips. Rotate the nameplate 180 degrees
and reassemble to the same holes. >
28 30926