Table of Contents
Advertisement
Section 6: User's Guide
Component Locations
A
B
C
Figure 6-1. Component Locations
A Battery Disconnect Switch
B Battery Status LED
C Intake Filter
D Front Cover
E Exhaust Vent
Battery Status LED
See
6-1. The color and strobing interval of LED
Figure
(B) communicates battery status.
Table 6-1. Battery Status LED
LED Color / Interval
Orange, solid
Orange, strobe (2s)
Green / Orange, alternating
Green, solid
Green, rapid blinking (0.5s)
Green, strobe (2s)
Red, rapid blinking (0.5s)
Red, strobe (8s)
Owner's Manual for Generac PWRcell Battery
Communication
All communication between REbus devices takes place
over the REbus conductors using Power Line Carrier
(PLC) communication. No additional communication
wiring or equipment is required for communication
E
between a PWRcell Inverter, PV array, and / or other
REbus enabled batteries.
System Operational Modes
The PWRcell system has several operational modes
available for various installation configurations, markets,
and applications. Operational modes are selected
through the PWRcell Inverter control panel. The inverter
prioritizes the distribution of power differently based on
D
the selected operational mode.
See the Generac PWRcell Inverter Installation and
Owner's Manual for complete instructions on configuring
the entire system for each operational mode.
Inverter Control Panel
See
PWRcell Inverter control panel. Use the inverter control
panel to enable or disable the battery, and to set the
operational mode for the system. See the Generac
PWRcell Inverter Installation and Owner's Manual for
012637
more information on settings and display screens.
Battery Status
Disabled
Waiting
Initializing
Charging
Discharging
Standby
Error
Sleeping
6-2. The battery is controlled through the
Figure
REbus
Shutdown
(hold)
Figure 6-2. Inverter Control Panel
User's Guide
Inverter
Internet
009894
35
Advertisement
Table of Contents
