Table of Contents
Advertisement
Phonebook (Storing Phone Numbers, Names, Distinctive
Rings and Speed Dial)
You can store names and numbers in your phone's phonebook, search for names
alphabetically, and dial phonebook entries with just a few key presses. You can
store up to 50 numbers in the base and up to 100 additional numbers in each
registered handset.
The phone uses the same memory to store phonebook entries and Caller ID
messages. If the shared memory is already full, the phone will not store any more
phonebook entries. You will have to delete some of the Caller ID messages before
you can store a new phonebook entry.
1) When the phone is in standby mode, press phonebook.
2) Press the STORE soft key,
3) Enter the name (up to 16 characters) by using the
number keypad (see the "Steps for Entering Names
and Special Characters" on page 42).
If a name is not required, go to step 4. <No Name> will be used as the name.
w w w . u n i d e n . c o m
appears.
S t or e /E di t N a me
•Base
•Handset
P H O N E B O O K [ 4 0 ]
note
•Selecting a phonebook
entry where a number
is already stored
overwrites the old
number. The new
number will be stored
in the phonebook entry.
•When the memory is
full, you will hear a
Memory Full
beep and
appears.
•The pause key counts
as one digit. Pressing
redial/p/vol/
on
the handset or the
PAUSE soft key on the
base more than once
increases the length of
the pause between
numbers. Each pause
represents a 2-second
delay.
Advertisement
Table of Contents
