LG ( 6023C / 8023C / 1023C) SUPER-SLIM WASHING MACHINES
b
d
21-Thermostat bulb rubber:
-Front panel is disassembled.
-Thermostat bulb is released from the tub cover.
-Thermostat bulb rubber is pulled by hand from the tub cover (Figure-13a).
(When mounting, thermostat bulb rubber should be fit well into its place in the tub cover)
22-Tub bellow:
-Remove the front panel.
-Remove the spring clamp that fixes the bellows to the tub cover.
-The bellow is pulled off by hand
(When mounting, the bellow holes should match the lower part of the tub cover)
23- Poly-V Belt:
-Back cover is disassembled
-Poly-V belt is pulled off while turning over the pulley (Figure-15)
-Clean up the pulley surface when mounting again.
b
C
Figure-14
Page 27
a
c
a
Figure-15