Candy CST 372L-S Manual page 100

- Press START/PAUSE
commence the delay start operation (the
indicator light
selected delay start time stops blinking
and remains on). At the end of the
required time delay the programme will
start.
l
It is possible to cancel the delay start by
turning the programme selector to OFF.
If there is any break in the power supply
while the machine is operating, a special
memory stores the selected programme
and, when the power is restored, it
continues where it left OFF.
The option buttons
selected before
START/PAUSE button.
EXTRA RINSE button
l
This option allows you to add one rinse at
the end of the washing cycle and is useful
for people with delicate and sensitive
skin, for which a small amount of
detergent residue can cause irritations or
allergies.
l
It is advisable to also use this function for
the children clothes and for the washing
of heavily soiled items, which requires a
lot of detergent to be used, or for the
washing of toweling items whose fibres
mostly have the tendency to hold the
detergent.
If the option is not compatible with the
selected programme,
indicator light first flashes and then
goes off.
TEMPERATURE SELECTION
button
l
This button allows you to change the
temperature of the wash cycles.
button
associated with
should
pressing the
the relevant
l
to
It is not possible to raise the temperature
over the maximum allowed for the
the
programme, in order to protect the
fabrics.
l
If you want carry out a cold wash all the
indicators must be off.
SPIN SPEED button
l
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
l
If the label does not indicate specific
information, it is possible to use the
maximum spin expected in the program.
be
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
l
To reactivate the spin cycle press the
button until you reach the spin speed you
would like to set.
l
It is possible to modify the spin speed
without pausing the machine.
An over dosing of detergent can
cause excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle
particularly unbalanced load. This
reduces the noise and vibration in the
machine and so prolongs the life of
your machine.
100
foaming. If
without load or
the
on