Behringer 2500 Manual page 18

Controls
1. GATE DELAY - Delays the envelope
cycle up to 3 seconds from the initial
gate input.
2. SIGNAL LED - Indicates when a gate
signal is present.
3. ATTACK TIME - Adjusts the rate at
which the envelope reaches its peak
voltage.
4. NITIAL DECAY TIME - Adjusts the
rate at which the envelope decays
from its peak to its designated
sustain level.
5. SUSTAIN LEVEL - Controls the level
at which the envelope remains after
its peak but before release,
sustaining as Long as the input signal
is present or the manual gate button
is held down.
6. FINAL DECAY TIME - Controls how
quickly the envelope falls after the
input signal stops or the manual gate
button is released.
7. TRIGGER MODE - Selects between
single mode, where only the gate
signal controls the envelope, or
multiple mode, which uses a positive
trigger pulse to re-trigger the
envelope while a gate signal is
present.
8. MANUAL GATE - Press and hold to
start the envelope cycle.
Patchpoints
9. GATE - Connect a gate signal to
control the envelope cycle.
10. TRIG- Triggers a new attack of the
envelope if a gate signal is also
present.
11. OUT L - Send the left envelope
positive and negatieve control
voltage to other modules via 3.5 mm
TS cable.
12. OUT R - Send the right envelope
positive and negatieve control
voltage to other modules via 3.5 mm
TS cable.