Table of Contents
Advertisement
ANTENNAICABLE CONNECTION
If you cannot obtain satisfactory reception with an indoor
antenna, using an outdoor antenna may be necessary.
Cable TV reception is only possible by connecting a cable
supplied by your local cable operator.
1 Remove the indoor antenna from the antenna terminal
of the TV.
2 Prepare the antenna or cable end using the appropriate
connector, and connect the antenna or cable to the
antenna terminal of the TV. (See A or B below.)
A | Combination VHF/UHF antenna*, VHF antenna, UHF
antenna or CATV cable
Select the proper connector according to the cable type.
When the cable is a 75-ohm
When
the cable is a 300-
coaxial type (round)
ohm ribbon type lead-in (flat)
a
Pts
©
<<
Use
an
optional
F-type
Attach the antenna connec-
connector.
tor.
Rear of TV
VHF/UHF
Antenna connector}
«Most combination antennas are equipped with a signal
splitter. Take
off the splitter and
attach
the proper
connector.
B [ When both VHF and UHF antennas are connected |
Prepare the VHF antenna end using the appropriate con-
nector as illustrated in A.
Attach an optional EAC-66 U/V mixer to the TV antenna ter-
minal, and connect the cables to the U/V mixer.
UHF
Rear of TV
VHF/UHF
0
When the cable is connected to the TV with the U/V mix-
er, snow and noise may appear in the pictures of the cable
TV channels over 37 (W +1).
Note to CATV system installer in the U.S.A.:
This reminder is provided to call the CATV system in-
staller's attention to Article 820-22 of the NEC that provides
guidelines for proper grounding and, in particular, specifies
that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable en-
try as practical.
Cc [ Cable with a special converter (decoder)
Pay cable TV systems use scrambled or encoded signals
and require special converters (decoders)* in addition to
the
normal
cable
connection.
Connect
the converter
(decoder) with a 75-ohm coaxial cable (optional).
AUX
Output
Special
converter
Pay TV
Cable
(decoder)
~The special converter (decoder) will be supplied by the
cable company.
lf the supplied antenna
connector has a slot as illus-
trated below:
The antenna connector can be used also as a U/V mixer.
When connecting both 75-ohm VHF and 300-ohm UHF
antennas, or 300-ohm UHF antenna only;
LT
Antenna
|
Connector
—
Should be Horizontal.
ome Q UH )
75 Q VHF
To turn the slot, use a coin or a similar object.
15
Advertisement
Table of Contents
