Table of Contents
Advertisement
UU869BH_TCX700 OM.fm Page 3 Wednesday, June 2, 2004 10:46 AM
Installing Your Expansion Handset
Follow these three easy steps before using your new cordless handset.
1
Install the battery pack.
2
Connect the charger and charge your new handset for 15-20 hours.
3
Register your new handset to the main base.
Step 1: Install the Battery Pack
1
Press down on the handset battery
case cover (use the finger indention
for a better grip) and slide the cover
downward to remove.
2
Plug the battery pack connector
(red & black wires) into the jack
inside the battery compartment.
(The connector notches fit into the
grooves of the jack only one-way.)
Match the wire colors to the polarity
label in the battery compartment, and
push the connector in until you hear a
click.
3
Make sure you have a good connection
by slightly pulling on the battery
wires. If the connection is secure, the
battery jack will remain in place.
4
Place the battery case cover back on
the handset by sliding it upwards
until it clicks into place.
5
Place the handset in the charging
cradle with the keypad facing forward.
• Use only the Uniden battery
(BT-446) supplied with your phone.
Replacement batteries are also available
through the Uniden Parts Department. (See
page 2.)
• Recharge your handset on a regular basis
by returning the handset to the charger
after each phone call.
Rechargeable Nickel-Metal-Hydride Batteries
Must Be Recycled or Disposed of Properly
–
–
3
Advertisement
Table of Contents
