DCT5285 SERIES WILL SUPPORT UP TO 4 HANDSETS. IMPORTANT The DCX520 will not operate unless it has been registered to a Uniden DCT5260 series, DCT5280 series, or DCT5285 series. Before the additional handset can be used, the battery must be charged and it must be registered with the base.
Page 3
“Please Register” appears in the display. Place the handset in the charging cradle with the keypad facing forward. The DCX520 will only work with “AA” Ni-MH rechargeable batteries. If you use any other type of batteries, the display will show “Use rechargeable battery only”.
Battery Information Battery use time (per charge) From fully charged (17-20 hours charge time) • Up to 7 hours continuous use (up to 5 hours when the Clarity Booster is On) • Up to 14 days when the handset is in the standby mode (up to 24 hours in the DirectLink mode) Low battery alert When the batteries are very low and need to be charged, the phone...
If the original unit has a built-in answering system, you can check your new messages, skip, repeat, or delete your messages with the DCX520 handset. For more instructions, see the owner’s manual supplied with the original unit. Polarity of the plug...
To playback a message To skip a message To repeat the current message Press the To repeat the previous message Press the To delete a message To stop operation • If you press end before the answering system answers, the phone will return to the standby mode.
(C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner’s manual for...
Need help?
Do you have a question about the DCX 520 and is the answer not in the manual?
Questions and answers