Computer Interface; Power Requirements; Built-In Nicd-Accumulators; Mains Adapter - Intab PC-Logger 2100 User Manual

7.4

COMPUTER INTERFACE

Computer communication is in serial form.
The serial standard is a subset of RS-232.
Format:
Baud rate:
7.5

POWER REQUIREMENTS

Voltage:
Current:
Current w/o charging batts. :
(Power via Vin or pin 3 of the TA3F connector. Voltage requirement in this case
is 10V.)
NOTE! With the display back-light on, the current consumption increases by ca
130mA.
(*) At elevated input voltages (>15V) the temperature inside the "2100" rises.
This affects measurement accuracy. (See also temperature coefficient).
7.5.1 Built-In accumulators
Charging time:
Capacity:

7.5.2 Mains Adapter

Voltage:
Current:
7.6

MECHANICAL

Length:
Height:
Width:
Weight:
Page 28
8 bit ASCII, 1 Start bit, 1 Stop bit, No parity bit
9600 Baud
ca. 24 hours for full capacity.
Should be left on charge even when not to be used for
longer periods
At least 8 hours continuous operation with fully charged
accumulators.
12-18V
Min 250mA
247mm
110mm
36mm
1.1kg
INTAB Interface-Teknik AB, Sweden
12-18V DC (*)
ca 60mA (charging current 35 mA)
ca 25mA