Advertisement
2. Service
Precautions
ON
3. Features
@
Quartz-locked
speed control system
©
Heavy aluminum die-cast platter of 2 kg cover
included
Inertia mass 280 kg-cm?.
of heat radiation,
Attach
an aluminum
plate (approx.
100 (W) x 100 (D) x 1 (H) mm
to the motor board).
If noise is produced when the knobs are turned or re-
placed, apply white grease or a small amount of silicon
(50 000 unit, a quarter of a drop) on the knob shafts
and the moving parts of the spring.
Note: Resin of the knob may be damaged if lubricating
oils other than those specified are used.
Cartridge it elliptical stylus employed. (Z-1TE)
Quick stop mecanism equipped.
Highly sensitive, New
Gimbal Suppot Tonearm
with an
effective length of 245 mm employed.
POWER
switch
Turn
the power
switch
ON.
Stroboscope
lamp
lights.
Speed select/STOP knob
Turn the knob to align the index line on the knob
with "33" or "45", depending on the rpm of the
record you wish to play.
33-1/3 rpm record (LP) .
.. "33"
45 rpm record (EP) ....
ae "45%
The platter stops within one revolution when the
index
line is aligned with the "STOP"
position
centered between the "33" and "45" positions.
Anti-skating knob
Arm lifter lever
Raise the lever to lift the
tonearm,
and lower
it for
the
tonearm
to descend
gently.
Stroboscope pattern
A single stroboscope
pattern
is equipped
on
the
rim of the platter. When the turntable rotates at
either 33-1/3
or 45 rpm,
the pattern
will appear
Stationary
to
indicate
that
the
turntable
speed
is correct.
No. 2428
Advertisement
