Page 1
ZEB Cam for Revo - GitUp G3 Camera Reset Overview In this article you can find all the steps required to reset your ZEB-CAM - GitUp. Note: Please check your camera model first to make sure you are following the correct procedure.
Page 2
3. Remove the SD card from the camera. 4. Power on the camera by pressing the Power/Mode button on the front of the camera. 5. Ensure the camera is set to video mode. Short press the Power/Mode button on the front of the camera to cycle between Video mode, Camera mode and Pre-view mode.
Page 3
8. Select the Reset Option to reset the camera to default settings. 9. Make the following camera settings: Camera settings System Settings Page Changes to Default Car DVR Ext power CHARGE MASS STORAGE Lock Auto Off 3 minutes Set Time Current date/time 10.
Page 4
Set up the video settings Video Settings Page Changes to Default Resolution 1440P4:3 Loop Microphone Stamp 13. Swipe down to exit the Video Settings page. 14. Power off the camera by long pressing the Power/Mode button. 15. Install the SD card in the camera. 16.