6. Install the power supply assembly.
7. Connect the power supply assembly cables to the system board.
8. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
E-lock
Prerequisite
Before you start, read Appendix B "Important safety information" on page 75 and print the following
instructions.
Note: To remove the screws, you need a special tool (T15 star wrench).
Replacement procedure
1. Remove the computer cover. See "Computer cover" on page 45.
2. Disconnect the E-lock cable from the system board.
3. Remove the E-lock.
.
Chapter 8
CRU replacement
67