Kenwood TM-631A Instruction Manual page 26

@ CALL Channel
1. Select the desired operating
frequency, offset, tone fre-
quency, etc. (For example
146.520 MHz)
2. Press the F key. The F in-
dicator and the memory
channel indicator will light.
(For example ch d)
3. Press the CALL key within
5 seconds of pressing the
F key. The F indicator and
the Memory channel num-
ber will turn off.
4. To confirm the CALL chan-
nel contents press the
CALL key and select the
Channel.
The NEW CALL channel
will appear.
——
vrompy
Sa
ALL
4-5-6. Memory Recall
Please refer to Frequency Selection page 16.
4-5-7. Memory Shift
This feature copies memory channel or CALL channel data
to the VFO.
This will allow you to after these frequencies without chang-
ing the actual contents of the memory or CALL channel.
1. Press the F key. The F in-
dicator and the memory
channel indicator will ap-
pear. (For example
146.100 MHz CH. 8)
2. Press the VFO key within 5
seconds of pressing the F
key.
a
46. 10g
uy
ej
vrompy
Note:
If the indicator goes off,
you must press the F key
again.
The data is copied to the
VFO mode.
Note:
If an Odd split Memory Channel (C or d) is selected, only
the receive data will be copied.