Kenwood TM-631A Instruction Manual page 11
Fm dual bander
Hide thumbs
Also See for TM-631A:
- Instruction manual (37 pages) ,
- Instruction manual (36 pages) ,
- Service manual (67 pages)
Table of Contents
Advertisement
@ T.ALT Key
This key is used to
turn
the Tone
Alert
function ON or OFF.
@ SHIFT key
This key is used to
select
the
desired
transmitter offset dur-
ing
repeater
opera-
tions. When the key is
pressed
the
shift
mode cycles from
+
to — [— to — — (Eu-
ropean
version)]
to
simplex (no indicator).
@ TONE key
This key is used to ac- |
tivate the subaudible
|
tone encoder.
@ REV key
This key is used
to
reverse the transmit/
receive
frequencies
during repeater opera-
tions. This will allow
you to check the input
of the repeater or to
operate on a reverse
repeater pair.
© MUTE key
This key is used to
reduce the volume of
the SUB
band
(Ap-
proximately 20 dB).
v
v
v
v
v
The F key is activate these keys below for 5 seconds after pressing the key, and during the "'F'' indicator is ON.
@L. OUT key
AL key
@ T. SEL key
STEP key
@ CTCSS key
This key is used
to
This key is used
to
This key is used
to
This key is used
to
With the TSU-6:
This
temporarily
skip un-
check Memory Chan-
switch to the tone fre- | | switch to the frequen-
key is used to activate
wanted
Memory
nel 1 at approx. 5 se-
quency _ selection
| cy
selection
mode
the CTCSS function.
Channels
during the
cond intervals. If the
mode.
| | during VFO operation.
Memory
Channel
channel
is busy,
a
The
MAIN
Tuning
The
MAIN
Tuning
Scan mode.
beep will sound.
control
can
then
be | | control
can
then
be
used
to
select
the
desired
tone
fre- |
quency.
|
used
to
select
the
desired
frequency
step.
Advertisement
Table of Contents
