Disassembly Procedures - Acer Nitro 5 Lifecycle Extension Manual

Disassembly Procedures

Safety Guidelines
This chapter contains step by step procedures on how to remove and de-install components from
the computer. Use the following safety guidelines to ensure your personal safety. Each procedure
included in this chapter assumes that you are preparing your computer for recycling and disposal.
By performing any of these procedures you acknowledge that any remaining warranty
applicable to your computer will be voided. Before you start any of the procedures in this
chapter, make sure to read the following safety guidelines and the respective instructions
within the chapter.
CAUTION!
• Turn off your computer and disconnect all power sources before opening the computer
cover or panels.
• To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface at the same time as touching a
connector on the back of the computer.
• Take off any metal objects on your arms or fingers such as bracelets, rings or watches
and make sure your hands are completely dry. Even if your unit is unplugged, there may
still be some remaining electric charge.
• If a component does not come out easily, do not forcefully remove it. Instead, check that
you are removing it correctly and that no wires or other parts are in the way.
• When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable
itself. Some cables have connectors with locking tabs; if you are disconnecting this type
of cable, press in on the locking tabs before you disconnect the cable.
Recommended Equipment
The following tools are required to perform maintenance on the notebook:
• Wrist grounding strap and conductive mat
• Flat screwdriver
• Philips screwdriver
• Pointed plastic pry or similar object
• Tweezers
Disassembly Procedures 1-3