Advertisement
LED Pedestrian 16x18'' Incandescent Look Signal Modules
Installation Steps
Verify input voltage is within specified range on the back of the
1
LED signal module before installation.
Failure to do so will cause lamp to fail.
2
Open front cover of (customer supplied) traffic signal housing.
Connect the wires to the appropriate terminal block within
3
customer supplied signal housing.
Orange wire ➔ (+ for Hand),
Blue Wire ➔ (+ for Person),
White wire ➔ (for the neutral).
4
Close front cover of (customer supplied) traffic signal housing
ensuring that the module gasket is tight within the housing.
To Test Countdown
NOTE: Module does not need to be disconnected
from terminal block.
1
Remove Cap from "CONNECT TO TEST"
2
Connect jumper wire using appropriate screws.
3
Re-install Cap over jumper location
To Stop Testing Countdown
1
Remove Cap from "CONNECT TO TEST"
2
Disconnect jumper wire and store it for future use.
3
Re-install Cap over jumper wire
Connect Jumper wire
to Test Countdown
A
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. GE and the GE
monogram are trademarks of the General Electric Company and are used under
license. Information and specifications subject to change without notice. All
values are design or typical values when measured under laboratory conditions.
To Disable Countdown
NOTE: Module does not need to be disconnected
from terminal block.
1
Remove Cap from "DISCONNECT TO DISABLE"
2
Remove jumper wire and replace screws for future use.
3
Re-install Cap over jumper location
To Re-Enable Countdown
1
Remove Cap from "DISCONNECT TO DISABLE"
2
Re-install jumper wire using appropriate screws.
A
3
Re-install cap over jumper wire.
Disconnect Jumper wire to
Disable Countdown
B
TRAF059-LED-Pedestrian-16x18-inch-lncandescent-Look-Signal-Modules-lnstallation-Guide
Installation Guide
Blue Wire
White Wire
Voltage
Rating
Countdown Option Jumpers (see below)
CAUTION
Orange Wire
Page 2 of 2
(Rev 06/21/23)
Advertisement
