Table of Contents
Advertisement
Remote control panel
Note:
If wireless remote controller is lost, open the surface panel and operate manually.
POWER BUTTON
1
Operation starts when pressing this button, and stops
when pressing this button again.
SWING BUTTON
2
Activate the automatic air swing function.
3
FAN SPEED BUTTON
Select the fan speed HIGH, MID, LOW and AUTO in sequence.
TEMP/TIMER BUTTON
4
Press the
keypad to increase the set (operating)
temperature of the unit. and Press the
decrease the set (operating) temperature of the unit.
The temperature seting range is from16~30
Press the
keypad also to increase the selected time
in 1 hour increments, and Press the
decrease the selected time in 1 hour decrements, The
time seting range is from 0~24 hours.
VENTILATION LEVER
Ventilation Lever
keypad to
keypad to
When the slider at the:
-"OPEN" position, the ventilation door
opens to allow air,smoke or odors to
be expelled from the room.
14
5
SIGNAL RECEIVER
MODE BUTTON
6
Select the operation mode, or AUTO,COOL,FAN, DRY.
FILTER BUTTON
7
This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation and
cooling. The LED (light) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press the
"Check Filter" button and the light will go off.
When the slider at the:
-"CLOSE" position, the ventilation door
is closed and the air will be circulated
inside the room and conditioned.
Advertisement
Table of Contents
