Changing The Engine Oil; Servicing The Air Cleaner - Toro Greensmaster 1018 Operator's Manual

Checking the Engine-Oil Level (continued)
7. If the engine-oil level is incorrect, add or drain oil to correct the level.
Note:
enough of the specified oil to raise the level to the upper limit mark
the oil fill hole)

Changing the Engine Oil

Oil may be hot after the engine has been run, and contact with hot oil can cause
severe personal injury.
Avoid contacting the hot engine oil when you drain it.
1. Shut off the engine and wait for all moving parts to stop.
2. Place a pan under the drain plug
the oil.
3. Remove the drain plug, washer
dipstick
4. Position the engine so that the oil drains from
the engine.
5. When the oil has drained completely, move the
engine to a level position and install the drain
plug and a new washer.
Note:
recycling center.
6. Slowly pour oil into the oil-fill hole until the oil is
at the correct level.
7. Ensure that the oil is at the correct level on the dipstick.
8. Thread the dipstick into the oil-fill hole.
9. Wipe up any spilled oil.
10. Connect the wire to the spark plug.

Servicing the Air Cleaner

Do not operate the engine without the air filter assembly; extreme engine damage will
occur.
If the oil level is near or below the lower level mark
.
Dispose of the used oil at a certified
WARNING
to catch
, and
G404894
IMPORTANT
7
on the dipstick, add only
(bottom edge of