Advertisement
When a disc is loaded the Display will show the number of Tracks and the Total Time on the
disc. More than 16 tracks on a disc will cause the display to read
OVER
in red. Pressing the
PLAY
button while the drawer is open will cause the drawer to Close and will start Play. The
Display will read
01
when you do this. You may pre select a track number before pressing Play
and the CD player will begin play with the selected track number. The track playing will "blink"
in the display. You may also
gently
push the drawer inward and it will close. The
STOP
button
will stop all functions and the Display will show the total track numbers and the total time on the
disc.
Pressing the
PAUSE
button will make the CD player stay in the same place on the CD and the
CD will still spin.
No sound will be heard until you press the Pause button or Play button to
resume playing the disc.
The red Pause indicator ( II ) will illuminate in the display next to the
Play arrow.
The
TRACK
buttons
(l«, »l)
will advance to the next Track (
»l)
or will go back to the
previous Track (l«) on the disc. If you are in the middle of a song and you press the l« Track
button once, the player will begin the same song again. If you press it twice,
quickly,
it will play
the previous song on the disc. If you are in Pause and you press the l« Track button once it
will proceed to the beginning of the same track and wait for you to press the Pause or Play
button. Pressing the »l Track button will cause the CD player to skip to the next track on the
disc.
The
PROGRAM
button will be used when you Program songs on the disc for play in a specific
order or to make a recording. To begin a Program, load a disc into the drawer and press the
Close button. The RCD 950 will read the table of contents on the disc. Press the Program
button on the CD player or the Remote Control. The display will show the word MEMORY and
P:01.
Next, select the Track Number you wish to Program. It will be displayed in the Display Panel.
Press the Program button again and the song will be entered into the Program memory. Repeat
this for the tracks you wish to program. The RCD 950 will remember up to 21 tracks in a
Program. The track numbers will illuminate in the display as you enter them into your
PROGRAM. You may check the song sequence entered into the program by pressing the
PROG button Pressing the Open
(OPN/CLS)
button will completely erase a Program from the
memory.
SCAN
will play the first 10 seconds of each song on a disc. The word INTRO will show in the
Display. The
RANDOM
function will play songs in a completely random way till the disc is
finished The word RANDOM will show in the display.
The
REPEAT
(REPT) button will allow you to play a song, the whole disc or programmed songs
repeatedly until you cancel this function by pressing REPEAT again or STOP The words
REPEAT 1 or REPEAT ALL are shown in the Display Panel, according to which function you
select This may be combined with RANDOM play as well.
The
A-B
button will allow you to create a "time loop" in a song. This is useful for learning the
words or chords in a song This feature could also be used for "sampling" segments of songs to
make a special effects recording. To use this feature select the place in a song that you wish to
repeat and press PLAY. Press the A-B button at the time you wish to start the loop. Allow the
disc to play until you reach the end point of the section you wish to loop and then press the A-B
button again This will create a
time loop
and the RCD 950 will repeat play this until you press
STOP or the A-B button again. The display will show A-B when you are using this feature
4
Advertisement
