US Robotics USR5453 Quick Installation Manual page 6

Step 1: Connect the Access Point to the Network and to Power.
The first USRobotics Professional Access Point in your network must be installed and config-
ured using an Ethernet cable. Make the following hardware connections:
1. Attach the antennas to the access point.
2. Connect one end of the supplied Ethernet cable to the LAN port on the access point,
and connect the other end to the same network that the administrator computer
uses.
Router
3. Connect the supplied power adapter to the 5.0 VDC port on the access point, and
plug the power adapter into a standard power outlet.
Note to UK Users: Replace the plug on the power adapter with the UK standard
plug that is supplied in your USRobotics package. Apply enough pressure to cause a
click and firmly seat the new plug in the adapter.
Router
2
Professional Access Point
Professional Access Point
Administrator
Computer
Administrator
Computer