English - Milwaukee SSD 1100 X Original Instructions Manual

TECHNICAL DATA
Reciprocating Saw
Production code
Rated input
Output
Stroke rate under no-load
Lengths of stroke
Weight according EPTA-Procedure 01/2003
Noise/Vibration Information
Measured values determined according to EN 60 745. Typically, the A-weighted noise levels of the tool are:
Sound pressure level (Uncertainty K=3dB(A))
Sound power level (Uncertainty K=3dB(A))
Wear ear protectors!
Total vibration values (vector sum in the three axes) determined according to EN 60745.
Cutting wood
Vibration emission value a
h
Uncertainty K=
WARNING
The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745
and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications,
with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over
the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is
running but not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories,
keep the hands warm, organisation of work patterns.
WARNING! Read all safety warnings and all instruc-
tions. Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury. Save all warnings and
instructions for future reference.
SAFETY INSTRUCTIONS
Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord. Cutting accessory con-
tacting a „live" wire may make exposed metal parts of the power
tool „live" and could give the operator an electric shock.
Appliances used at many different locations including open air
should be connected via a residual current device (FI, RCD, PRCD) of
30mA or less.
Always wear goggles when using the machine. It is recommended
to wear gloves, sturdy non slipping shoes and apron.
Sawdust and splinters must not be removed while the machine is
running.
Before doing any work on the machine, pull the plug out of the
socket. Only plug-in when machine is switched off.
Keep mains lead clear from working range of the machine. Always
lead the cable away behind you.
The dust produced when using this tool may be harmful to health.
Do not inhale the dust. Wear a suitable dust protection mask.
Do not use cracked or distorted saw blades.
Plunge cuts without pre-drilling a hole are possible with soft ma-
terials (wood, light building materials for walls). Harder materials
(metals) must first be drilled with a hole corresponding to the size
of the saw blade.
Always place the guide shoe on the workpiece when sawing.
When working in walls ceiling, or floor, take care to avoid electric
cables and gas or waterpipes.
SPECIFIED CONDITIONS OF USE
This sabre cut is intended to cut wood, plastic, and metal. It can cut
straight lines, curves, and internal cut-outs. It cuts pipes and can
cut flush to a surface.
Do not use this product in any other way as stated for normal use.
SSD 1100 X
4107 81 01...
4167 11 01...
4290 01 01...
... 000001-999999
1100 W
550 W
0-3000 min
-1
28 mm
3,2 kg
91 dB (A)
102 dB (A)
GB
26 m/s
2
1,5 m/s
2

English

5