Zanussi FCS 920 C User Manual page 8

Select the desired option by means of buttons 3, 4
and 5
Depending on the programme, different functions can be
combined. These must be selected after choosing the de-
sired programme and before pressing the button 6. The
relevant light will illuminate.
If an incorrect option is selected, the corresponding indi-
cator lamp flashes for about 2 seconds. For the compati-
bility of the options with the washing programmes, refer to
the chapter «Washing programmes».
Select the Delay Start by pressing button 2
Before you start the programme, if you wish to delay the
start, press the button 2 repeatedly, to select the desired
delay. The corresponding pilot light will light up.
You must select this option after you have set the pro-
gramme and before you press button 6.
You can cancel or modify the delay time at any moment,
before you press button 6.
Cancelling the delayed start after having pressed button 6:
1. Set the washing machine to PAUSE by pressing but-
ton 6.
2. Press the button 2 once, the light relevant to the se-
lected delay goes off.
3. Press button 6 again to start the programme.
Important! The selected delay can be changed only after
selecting the washing programme again.
The door will be locked throughout the delay time (door
locked light lit).
8
The Delay Start can not be selected with DRAIN or SPIN
programme.
Start the programme by pressing button 6
To start the selected programme, press this button; the
corresponding pilot light stops flashing and remains lit.
On programme progress display the pilot lights A and E
illuminate to indicate that the appliance starts operating
and the door is locked.
Altering an option or a running programme
It is possible to change any option before the programme
carries it out.
Before you make any change, you must pause the washing
machine by pressing the button 6.
The programme can be changed as long as the button 6
has not been pressed. Changing a running programme is
possible only by resetting it. Turn the programme selector
dial to and then to the new programme position. Start
the new programme by pressing the button 6 again.
Interrupting a programme
Press the button 6 to interrupt a programme which is run-
ning, the corresponding light starts to flash. Press the
button again to restart the programme.
Cancelling a programme
Turn the selector dial to
gramme which is running. Now you can select a new pro-
gramme.
Opening the door after the programme has started
First set the machine to pause by pressing the button 6.
After some minutes, the door can be opened, when the
following conditions are observed:
• The water temperature is below 55°C.
• The water level is below the bottom edge of the door.
• The machine doesn't spin.
If you cannot open the door but it is absolutely necessary
to open it you have to switch the machine off by turning
the selector dial to . After few minutes the door can be
opened
(Pay attention to the water level and temperature!).
After this procedure, it will be necessary to set the pro-
gramme and the options again and then press the button
6.
At the end of the programme
The machine stops automatically.
position to cancel a pro-