Table of Contents
Advertisement
Troubleshooting
Problem
Vibrates excessively or
makes noise.
Stops.
Fills with the wrong
temperature water.
60
English
Untitled-1 60
• Make sure the washing machine is on a level floor. If the floor is not
level, use the levelling feet to adjust the washing machine.
• Make sure the washing machine is not contacting any other object.
• Make sure the laundry load is balanced.
• Make sure the laundry is spread evenly in the washing machine.
Spread out the laundry evenly and start again.
• Make sure the space around the washing machine is free of objects.
• Humming is produced normally during operation.
• Objects such as coins can cause noise. Remove these objects from the
washing machine after washing is complete.
• Make sure the washer's power cord is fully plugged in and the circuit
is live.
• Check the fuse or reset the circuit breaker.
• Close the door, and then press or tap Start/Pause (Hold to Start) to
start the washing machine. For your safety, the washing machine will
not spin unless the door is closed.
• Before the washing machine starts to fill, it will make a series of
clicking noises to check the door lock, and then does a quick drain.
• There may be a pause or soak period in the cycle. Wait briefly and the
washing machine may start.
• Make sure the inlet hose filters at the taps are not clogged.
Periodically clean the filters. See page 56.
• This problem can occur temporarily due to low voltage in your
household electrical system. It will be resolved when the voltage
returns to normal.
• Fully open both water taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct water taps. Flush
the water lines.
• Disconnect the hoses and clean the mesh filters. The water inlet
mesh filters may be clogged. See page 56.
• While the washing machine fills, the water temperature may change
as the automatic temperature control feature checks incoming water
temperature. This is normal.
• While the washing machine fills, you may notice just hot and/or
just cold water going through the dispenser when cold or warm
temperatures are selected. This is a normal function of the automatic
temperature control feature as the washing machine determines the
water temperature.
Action
2023-04-28
6:01:06
Advertisement
Table of Contents
