Initial Setup; Turning The Tv On For The First Time - JVC LT-32C655(A) Instruction Manual

Chapter
3
3

Turning the TV On for the First Time

LAN
SPDIF VGA
Coax.OUT
SCART
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on
the back of your TV.
Do not connect the TV to the mains supply until you have completed all the connections.
le
LAN
VGA
SPDIF
Coax.OUT
SCART
2. Connect the Wi-Fi Dongle to one of the USB sockets on the back of your TV.
The dongle can be plugged directly into the TV or you can use the Extender. Plug your Dongle into the Extender, then plug the
Extender into a USB port on your TV. The extender enables you to move the Wi-Fi Dongle further away from your TV if you find
your Wi-Fi signal is weak.
3. Plug the TV into a mains socket and switch on at the mains.
4. In standby mode, press the
then the TV will switch on.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
16

Initial Setup

SPDIF
Coax.OUT
USB
5Vdc
Max. 500mA
USB
5Vdc
Max. 500mA
button on the remote control to turn the TV on. The LED indicator will flash for a few seconds
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
LAN
VGA
SCART
RF coaxial cable
(not included)
Wi-Fi Dongle and Extender (supplied)
Connect the Wi-Fi dongle
using the Extender if your
Wi-Fi signal is weak. It enables
you to move the dongle
further away from your TV.
LAN
SPDIF VGA
Coax.OUT
SCART