Explosion Hazard - Bresser MicroCam MINI Full HD HDMI Instruction Manual

• To disconnect the camera from the mains
supply, always pull on the mains plug and
never on the cable!
• Check the camera, cables and connections
for damage before use. Never use a
damaged camera or power adapter.
• Damaged parts
immediately by an authorized service
centre.
• Only operate the camera in a completely
dry environment.
• The camera is equipped with a power
pack (output: 12V,1A)
• To avoid electric shock, connect the
supplied power cord to a properly
grounded outlet.
DANGER OF SUFFOCATION!
Improper use of this product may result
in suffocation, especially for children. It is
therefore imperative that you observe the
following safety information.
• Keep packaging materials (plastic bags,
rubber bands, etc.) away from children!
There is a danger of choking!
• Keep cables, straps and similar materials
away from children - risk of suffocation!

EXPLOSION HAZARD!

Improper use of the camera and accessories
can lead to an explosion!
It is essential that you observe the following
safety information in order to avoid fires.
• Do not expose
accessories to high temperatures and
extreme temperature fluctuations.
• Only use the power pack supplied by
BRESSER. Do not short-circuit the camera
or throw it into a fire!
• Excessive heat and improper handling
can cause a short circuit, fire or even an
explosion!
• Do not use the camera and the supplied
accessories in explosive environments,
or in the presence of flammable solvents
must be replaced
the camera and
such as alcohol, gasoline, or volatile
anaesthetic agents.
NOTE:
DANGER OF MATERIAL DAMAGE!
Improper handling may damage the camera
and/or accessories. For this reason, only use
the camera in accordance with the following
safety information:
• Observe all safety instructions and the
operating instructions for the devices to
which the camera is connected.
• Use in commercial facilities: always comply
with the applicable occupational health and
safety regulations for electrical systems
and equipment.
• Use in schools, training institutions,
hobby or DIY workshops: Monitoring and
operation exclusively by trained personnel.
• Do not disassemble the camera! Do
not attempt to disassemble or replace
connectors, optical systems or mechanical
parts yourself. In the event of a defect,
please contact your dealer. The dealer will
contact the service centre and send the
device for repair if necessary. The camera
and its accessories should only be serviced
and repaired by trained personnel.
• Do not expose the camera and its
accessories to high temperatures, extreme
temperature changes, high humidity, water
or chemicals (acids and vapours, alkaline or
caustic and corrosive materials).
• Protect the camera from grease and oils.
• Protect the camera from direct sunlight
and direct proximity to radiators.
• Do not subject the camera to physical
shock!
• Only use accessories and spare parts for
the camera that correspond to the technical
specifications.
• Always use the mains cable supplied by
BRESSER. If an unsuitable mains cable
is used, BRESSER cannot guarantee the
- 25 -
EN