Advertisement
TE-4602
Tinytag Plus LAN Data Logger with Two Temperature & Relative Humidity Probes
(-25 to +85°C/0 to 100% RH) x 2
Calibration
This logger is configured to meet Gemini's quoted accuracy specification
during its manufacture.
We recommend that the calibration of this unit should be checked annually
against a calibrated reference meter.
A traceable certificate of calibration can be supplied for an additional charge
either at the point of purchase, or if the unit is returned for a Service
Calibration.
Warranty
This product carries a manufacturing defects warranty of 12 months from the
date of purchase. Units returned under warranty will be repaired or replaced at
the manufacturer's discretion. This warranty does not cover mishandling,
modification or battery replacement and is subject to our standard Terms and
Conditions of Sale, a copy of which can be found at www.tinytag.info.
Approvals
Gemini Data Loggers (UK) Limited hereby declares that this data logger is in
compliance with the essential requirements and other relevant provisions of
EMC directive 2014/30/EU and RoHS directive 2011/65/EU. A copy of the
declaration of conformity is available upon request.
This logger also conforms to the following EMC standards EN 61326-1:2013,
FCC/CFR 47:Part 15:2016 & Canadian Standard ICES-003:Issue 6.
This logger also complies with (RJ45) 10/100Mb Base-T for Ethernet
connectivity and PoE standard IEEE 802.3af.
Gemini Data Loggers (UK) Ltd. operates a Business Management System
which conforms to ISO 9001 and ISO 14001.
Required and Related Products
Required Parts
Two Ethernet cables (not supplied) are required to connect this receiver
to a LAN.
This logger is a PoE device and is supplied with a PoE injector as standard. If
the logger is being used on a powered network, or a number of loggers are
being connected to a powered hub, this product can be supplied without the
injector.
When used as a standalone device, a copy of the following software is
required:
SWCD-0040 Tinytag Explorer
When used as part of a Tinytag Connect system, a copy of the following
software is required:
SWCD-0080 Tinytag Explorer Connect
Probes
This logger uses 2 x PBRF-8002 probes, which are fitted to the loggers using
CAB-0034 extension cables for Plus & Ultra radio temp/RH probes, 1.5m (two
of each of these are supplied with the logger).
If a cable length of greater than 1.5m (up to a maximum of 10m) is required,
an additional CAB-0040-XM cable will be required.
2 x ACS-0045 Radio RH Probe Clips are also supplied with the logger.
Further Related Products
ACS-0040 RJ45 waterproof (IP67) Shroud (supplied)
ACS-0041 PoE Injector (supplied)
CAB-0040-XM Connection cable for Radio temp/RH probes (up to 10m)
CAB-0041 Plus LAN alarm output lead
www.tinytag.info
sales@tinytag.info
Issue 2 (27th October 2023) E&OE
Advertisement
