Installation Instructions – AP2SQLED30 Emergency Unit
Important Safeguards
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
WARNING: RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT
IS ENERGIZED.
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR
SIGNIFICANT PROPERTY DAMAGE - For your protection, read and follow these warnings and instructions carefully before
installing or maintaining this equipment. These instructions do not attempt to cover all installation and maintenance
situations.
• READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
All service shall be performed by qualified service electrician. This product must be installed and maintained in
•
accordance with the applicable installation codes by a person familiar with the construction & operation of the
product and the hazards involved.
This product must be installed in accordance with the applicable installation codes and ordinances.
•
Before wiring to power supply, turn off electricity at fuse or circuit breaker.
•
Disconnect AC power and unplug battery before servicing.
•
Consult your local building code for approved wiring and installation.
•
Do not let power supply cord touch hot surfaces.
•
Do not mount near gas or electric heater.
•
Equipment should be mounted in locations and at heights where it will not
•
readily be subjected to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition
•
Do not use this equipment for other than intended use.
•
Connect to an AC voltage as recommended on the product label of this equipment.
•
SAVE THESE INSTRUCTIONS.
Schematic:
Unused input lead must be properly insulated with
N
ote:
wire nut or other approved method.
RED
277V
BLACK
120V
WHITE
0V
2
COOPER LIGHTING SOLUTIONS
CHARGER
BOARD
RED
BLACK
BATTERY
TEST
LED indicator
IB50561122
Installation instructions