Pioneer CT-W205R Service Manual page 9

CT-W205R
4. TEST MODE
4.1 Entering the Test Mode
STOP Mode
® Press the STOP key of deck I, MUTE, and PAUSE keys of deck II simultaneously to enter the test mode.
4.2 Exiting the Test Mode
© Press the STOP keys of deck 1 and deck 2 together. (Because the RESET key is not provided for this unit)
® Inputting the STANDBY Key (If the STANDBY key is available)
® Power OFF
The test mode can be exited by any one of the above.
4.3 Main Test Mode Items
@ SW Check
4.3.1 SW Operation Check
SW operations are as follows in the test mode.
-oo goes off All keys except « In this mode, the mechanism operates without the half.
REWIND
AUTO PLAY ¢ SW check
When the switch is pressed, the level meter lights up or blinks as shown in Table 1, enabling
switch operations to be checked.
Table 1
When the REV mode is
sel to
= : Blinks quickly
© : Blinks slowly
When DOLBY NR is set to Lights up when the half | Lights up when the CrO2
B : Blinks quickly switch of deck I is{ switch of deck I is
C : Blinks slowly pressed, pressed.
Lights up when forward | Lights up when the metal | Lights up when the half | Lights up when the CrO2 | Lights up when reverse
recording inhibit switch | switch of deck II is | switch of deck II is} switch of deck II is| recording inhibit switch
of deck II is pressed. pressed. pressed. pressed. of deck II is pressed.
4.3.2 x2 Speed Check
In the test mode, play the unit and complete assist operations (to stabilize mechanism operations), and then press ff or rew to set
x2 speed play.
Press PLAY again to set normal speed play.
11