Table of Contents
Advertisement
OPERATION
.
BRAKE PEDALS (Figure 24)
The brake pedals are conveniently located to right and
front of operator. They may be operated individually to
aid in turning, or operated together when stopping for¬
ward and rearward motion of tractor.
When stopping, apply pressure evenly to both pedals.
The pedals may be latched together for driving on high¬
way. To aid in turning during field use, apply brake for
side to which tractor is being turned.
CAUTION:
DO NOT attempt short turns at
high speeds.
T-69372
FIGURE 24
1.
Brake Pedals
2.
Brake Lock Lever
BRAKE LOCK LEVER (Figure 24)
The brake lock lever is located to right of operator and
is used when locking brake pedals in applied position.
If it is desired to lock both brakes, brake pedals must
be latched together, as lock is applied to one pedal
only.
To lock brake pedals in applied position, move brake
lock lever up and depress brake pedals. To release
brakes, depress brake pedals. Be sure brakes are re¬
leased before operating tractor.
P.T.O. SHAFT OPERATION (Figure 25)
CAUTION:
Make sure P.T.O. shield is in
place.
NOTE:
It is recommended that top hitch point hole in
upper link attaching bracket be used for upper link
when operating fully mounted P.T.O. driven equipment.
This will provide minimum change in drive line tilt
when an implement is lifted and maximum clearance
between upper link and theP.T.O. shield.
38
'VS**--'-
Advertisement
Table of Contents
