To Our Dealer - Simplicity 9518 Series Operator's Manual

Compact diesel tractor
Hide thumbs Also See for 9518 Series:
Table of Contents

Advertisement

TO OUR DEALER
_TO OUR DEALER_
_DEALER'S PREDELIVERY SERVICE GUIDE FOR 15 PTO HP TRACTOR_
DETAILS OF ITEMS LISTED BELOW ARE COVERED IN THIS OPERATOR'S MANUAL OR IN THE
SERVICE MANUAL
SHIPPING DAMAGE
Tractor has been checked for shipping damage.
TRACTOR SET-UP
This tractor has been completely set-up in accord
with the Tractor Set-Up Instruction supplied with
the tractor.
PRE-OPERATIONAL CHECK, do before engine is started.
COOLANT LEVEL is between FULL & ADD MARK on
over flow bottle.
ENGINE OIL LEVEL is between "FULL" and "ADD"
marks on dipstick.
TRANSMISSION - HYDRAULIC System OIL LEVEL is
up to level mark.
AIR CLEANER ELEMENT is clean and properly
installed.
FWD axle oil level (if unit so equipped)
All air intake hoses and clamps are properly in¬
stalled and tightened.
A sufficient quantity of No. 2 diesel fuel for all
normal predelivery operation has been placed in the
fuel tank.
All Safety and Operational Decals & SMV Emblem
are properly installed and fully legible.
Check oil level in injector pump.
OPERATION AND ADJUSTMENT
Tire pressures are set within the pressures listed in the
Tires Pressure and Load Tables for the size tires on
this tractor.
Fan belt is properly tightened.
Battery electrolyte is at the indicator level and the
specific gravity is 1.240 or above in each cell.
Instruments and warning lights operate correctly.
Wheel guard lights are properly connected to the trac¬
tor wiring harness and all lights operate correctly in
the various light switch positions.
The safety start switches on clutch pedal & PTO shift
lever do not allow engine to start unless they are both
in disengaged position.
The brakes function properly and are adjusted
correctly.
The clutch functions properly and is adjusted correctly.
The engine Glow Plugs operate and the engine starts
correctly.
Throttle and fuel shutoff linkage operate correctly.
Engine low idle speed is 700 to 800 RPM, and high idle
speed is 2750 to 2850 RPM after engine is warmed up
to operating temperature.
Hydraulic relief pressure is approx. 1900 PSI (13100
kPa) at 2500 engine RPM.
All hydraulic functions operate correctly.
Transmission gear shift and range shift levers operate
smoothly in all gears.
Tractor operates properly in all gears.
After tractor has been operated and thoroughly warmed
up there are no leaks of:
a.
engine oil.
b.
power train and hydraulic oil.
c.
radiator coolant.
Coolant anti-freeze tests to -20° F (-29° C) or lower.
All grease fittings on the tractor have been lubricated.
Overall appearance of tractor is clean and new.
Operator's manual is with the tractor

Advertisement

Table of Contents
loading

Table of Contents