Faults and what to do about them
en
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
Ì on the display panel
and drying has been
interrupted.
¥ on the display panel. Clean the fluff filter and press the Start button ~ Page 28.
selfCleaning on the é
display panel.
Dryer will not start.
Creasing.
Water is leaking out.
Change in the pro-
gramme duration dis-
played during drying.
* Depending on the model
34
Cause/remedy
Empty the condensation container and press the Start button
■
~ Page 29.
If the optional condensation drain* is installed, the drain hose may be
■
blocked or kinked. Check the hose for deposits and rinse the hose. Lay the
hose without any kinks.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out the
condensation container while this is displayed.
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate childproof lock.
■
"Ready in" time selected? Programme starts after a delay ~ Page 26.
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table ~ Page 24.
Remove clothes immediately after drying; creasing will occur if they are left
■
in the drum.
Not a fault; the dryer may be sloping. Level the dryer.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).