Kenwood TS-930S Instruction Manual page 31

6.4 AT-930 INSTALLATION
YK-89A-1
(1) Remove the top and bottom cavers (16 screws, total)
| from the transceiver.
(2) Remove the 4 screws and cable retainers located in
the AT-930 mounting space.
{3} Using a long-nosed plier, carefully disconnect the
coaxial cable from the filter unit ANT terminal
CAUTION:
Coax leads with connectors are not repairable. When connecting
or disconnecting, do not break the male or female connectors.
(4) Secure the AT-930 to the transceiver using 4 screws.
CAUTION: ~~~.
Do not pinch any leads between the AT-930 and transceiver
chassis.
(5) Install the multi-connector to the AT-930.
{6) Connect the coaxial cable, which was removed from
hae the filter unit, to the AT-930 MAT terminal.
— (7) Connect the supplied coaxial cable between the
AT-930 ANT terminal and the fitter unit ANT terminat,
(8) Replace the transceiver top and bottom covers. The
AT-930 is now ready for automatic operation.
AT-230 mounting
apace 3
Fig. 6-18
YG-455C-!
YG-455CN-1
AT-i0
FEES ETS]
SORETEED
= v
els yeast 1 |
t
t
Wh YG-ASSCN-E
| 1.
3}