Advertisement
•It is recommended that you keep you hands off the motors when they are hot.
•If you desire to know the temperature of the motor do the following:
1. Place a 200°F thermometer on the frame of the motor.
2. Place a glob of putty over the bulb of the thermometer.
3. Take the temperature readings.
•Also, do not forget we use a thermal protected starters on Terrco® machines, and this protects the motor against low
voltage and overload conditions which might raise the temperature of the motor beyond safe limits.
•15% less in the 5 HP size.
•9-1/2% less in the 7-1/2 HP size.
•42-1/2% less in the 5 HP size.
•34-1/2% less in the 7-1/2 HP size.
•No brushes.
•Less internal wiring.
•Six leveling adjustments.
•1/8" increments
•Easier to "break" machine when changing stones.
1. A er removing the weighs, unscrew safety knob (Ref. number 107), push knob (Ref. number 18) to the rear to release
the locking mechanism. Raise handle two or three notches, lock handle by reversing the above procedure and tilt stone
holders off the oor.
2. Pushing the handle for ward two or three notches creates a safe stone position for changing, as the machine will not
have a tendency to " ip-up". It also makes it much easier to get at the stone changing area.
•The adjustable handle is very easy to operate. You merely unscrew the safety knob (Ref. number 107), push knob
(Ref. number 18) to the rear to release the locking mechanism. When you have raised or lowered the handle to your
desired position, push knob (Ref. number 18) forward as far as you can and screw the safety knob (Ref. number 107)
tight. This will lock the handle in position.
•Make sure that you have pulled knob (Ref. number 18) completely to the rear to assure full unlocking of mechanism
and the safety knob (Ref. number 107), is screwed up tight.
Advertisement
