Yamaha YZ 2023 Series Owner's Service Manual page 152

6. Install:
• Handlebar grip "1"
a. Slightly coat the handlebar left end with a
rubber adhesive.
b. Install the handlebar grip on the handlebar
by pressing the grip from the left side.
c. Wipe off any excess adhesive with a clean
cloth.
TIP
Install the handlebar grip to the handlebar so
that the line "a" between the two arrow marks
faces straight upward.
a a
7. Install:
• Clutch cable "1"
TIP
Before installation, apply the lithium-soap-based
grease to the clutch cable end.
8. Adjust:
• Clutch lever free play
Refer to "ADJUSTING THE CLUTCH LEVER
FREE PLAY" on page 3-15.
Clutch lever free play
7.0–12.0 mm (0.28–0.47 in)
9. Install:
• Right grip "1"
• Collar "2"
Apply adhesive to the tube guide "3".
TIP
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface "a" with a lac-
• Install the grip to the tube guide so that the grip
1
10.Install:
TIP
Apply the lithium-soap-based grease on the
throttle grip sliding surface.
1
11.Install:
TIP
Slightly coat the end of throttle cable and inside
of throttle grip with lithium-soap-based grease.
Then, mount the throttle grip onto the handlebar.
4-38
quer thinner.
match mark "b" and tube guide slot "c" form the
angle as shown.
b
1
• Rubber cover "1"
• Throttle grip "2"
1
• Throttle cable "1"
HANDLEBAR
64 64
c
3
2