Advertisement
11.1.2.1.1 Distance 2 Points
Note
11.1.2.1.2 Distance 2 Lines
Note
11.1.2.1.3 Length Trace
Note
11.1.2.1.4 Length Point
Note
11.1.2.1.5 Stenosis %Distance
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
1.
To measure the distance between two points, select the [Dist. 2Point] item in the menu
area. A cursor appears on the screen.
2.
Use the trackball to move the cursor to the start point of the measurement and press the
right or left trackball key [Set] to fix the marker. A second cursor appears.
3.
Move the second cursor to the second point of the measurement and press [Set] again.
To re-adjust the start point, press the upper trackball key [Change] before completing the
measurement. This alternates the control from one cursor to the other.
1.
To measure the distance between two lines, select the [Dist. 2Line] item in the menu
area. A line appears on the screen.
2.
Move the line to the start point of the measurement and press the right or left trackball
key [Set].
To re-adjust the start point, press the upper trackball key [Change].
3.
Move the trackball to adjust the angle and then press [Set] again. A second line (parallel
to the first one) appears.
4.
Move this line using the trackball to the end point of the measurement and then press
[Set].
1.
To measure the distance between two points using trace, select the [Length Trace] item
in the menu area. A cursor appears on the screen.
2.
Move the cursor to the start of the measurement and press the right or left trackball key
[Set] to fix the marker. Begin trace.
To re-adjust the traced line, press the upper trackball key [Undo] repeatedly.
3.
Trace to the end and press the [Set] key again to fix the mark.
1.
To measure the distance between several points (as much as desired), select the
[Length Point] item in the menu area. A cursor appears on the screen.
2.
Move the cursor to the start of the measurement and press the right or left trackball key
[Set] to fix the marker.
3.
Move the trackball again to adjust the next line between two points and then press [Set]
again.
To re-adjust a line, press the upper trackball key [Undo] repeatedly.
4.
Set as much points as required in the same manner.
5.
To finish the measurement and to display the result, press the [Set] key once again.
1.
To measure a Stenosis, select the [Stenosis %Dist] item in the menu area. A cursor
appears on the screen.
2.
Perform the measurement of the outer distance of the stenosis using the trackball and
the right or left trackball key [Set]. A second cursor appears.
3.
Perform the measurement of the inner distance of the stenosis and press the [Set] key.
Measurements and Patient Worksheets (Reports)
11-7
Hide quick links:
Advertisement
Chapters
