Inalto IFL80D50W User Manual page 5

Installation Location and Surrounding
• All washing and additional substances are to be kept
in a safe place out of the reach of children.
• Do not install the machine on a carpet floor.
• The obstruction of the openings by a carpet can damage
the machine.
• Keep the appliance clear from heating sources and direct
sunlight to avoid plastic and rubber parts to corrode.
• Do not use the appliance in humid environments or
rooms containing explosive or caustic gas. In case of
water leakage or water splashes, let the appliance dry in
the open air.
• The appliance must not be installed behind a lockable
door, a sliding door or a door with a hinge on the opposite
side to that of the machine .
• Do not operate the machine in rooms with a temperature
of below 5°C. This can cause damages to parts of it. If it
is unavoidable, make sure to drain the water completely
from the appliance after every use (see "Maintenance
- Cleaning the drain pump filter") to avoid damages
caused by frost.
• Never use flammable sprays or substances in the
immediate proximity of the appliance.
• That lint must not to be allowed to accumulate around
the washer dryer (not applicable for appliances intended
to be vented to the exterior of the building).
Installation
• Remove all packaging material and transport bolts
before using the appliance. Otherwise, serious damage
may result.
• This appliance is equipped with a single inlet valve and
can be connected to the cold water supply only.
• Mains plug must be accessible after installation.
• Before washing clothes for the first time, the product
shall be operated once throughout all the procedures
without any clothes inside.
• Before using the machine, the product shall be calibrated.
• Do not put any excessively heavy objects on the
appliance, like water containers or heating devices.
• The new hose-sets supplied with the appliance are to be
used and that old hose-sets should not be reused.
• Max. Inlet water pressure 1 MPa. Min. inlet water pressure
0.05 MPa.
Electrical Connection
• Make sure the supply cable is not trapped by the
machine, or it can get damaged.
• Connect the product to a grounded outlet protected
by a fuse complying with the values in the "Technical
specifications" table. The grounding installation has to be
made by a qualified electrician. Ensure that the machine
is installed in accordance with the local regulations.
• Water and electrical connections must be carried
out by a qualified technician in accordance with the
manufacturer's instructions and local safety regulations.
• WARNING: Don't use multiple plugs or extension cords.
• The appliance must not have an external switching device
such as a timer or connected to a circuit that is regularly
switched on and off.
• Do not pull the plug out of the mains outlet if there is
flammable gas around.
• Never pull out power plug with wet hands.
• Always pull at the plug, not at the cable.
• Always unplug the appliance if it is not being used.
Water Connections
• Check the connections of the water inlet tubes, the water
tap and the outlet hose for possible problems due to
changes of water pressure. If the connections loosen or
leak, close the water tap and get it repaired.
• Do not use the appliance before the pipes and hoses are
installed properly by qualified persons.
• Glass door may become very hot during the operation.
Keep children and pets far away from the machine while
it is operating.
• The water inlet and outlet hoses have to be safely
installed and remain undamaged. Otherwise, water
leakage can occur.
• Do not remove the drain pump filter while there is still
water in the appliance. Big quantities of water can leak
out, and there is a risk of scalding due to hot water.
05