Installation Of The 2015R; Relocating The Shelves; Installation Troubleshooting - U-Line Echelon 2015R Installation Manual

8 Install the Unit

Installation of the 2015R

1. Plug in the power cord.
2. Gently push the unit into position. Be careful not to
entangle the electrical cord.
3. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.

Relocating the Shelves

Both the glass shelves in the refrigerator and the inner
door shelves can be moved to accommodate your bottles,
cans and containers.
Glass Shelves
1. Open door fully, grasp shelf firmly, lift front edge
slightly, and pull straight out.
2. Choose new location and slide shelf onto the
appropriate rib.
Door Shelves
1. First pull shelf up at a 45°
angle, then straight out
(see Figure 33).
2. Choose new location and
line up on bosses. First
push straight in, then
down at a 45° angle.
www.U-LineService.com
2015R — Refrigerator
Notch
Boss
Figure 33

Installation Troubleshooting

Q:
Problem
The door remains open unless it is pushed closed.
A:
Solution
The hinges should be self-closing when the door is open
approximately 8". If this is not the case, make sure the
closers (at the bottom of the hinge pin) are clean, greased
and installed correctly. Also, re-check leveling from front
to back of the unit and readjust if necessary. Make sure
that pivot plate is installed correctly.
Q:
Problem
The custom overlay door was designed to align with the
rest of the cabinet doors, but the unit has crept forward.
A:
Solution
Make sure that the electrical cord is not obstructing the
installation.
14
™
02/2005