Advertisement
Quick Links
Connecting the BOSS
TONE STUDIO Android app
to the KATANA-AIR unit
© 2018 Roland Corporation
For details on how to use BOSS TONE STUDIO, refer
to the "Using BOSS TONE STUDIO for KATANA-AIR"
PDF.
* When using Android 6.0 or later, turn Location
mode for the Android device on.
* You can use BOSS TONE STUDIO for KATANA-AIR
on both the KATANA-AIR and KATANA-AIR EX
(hereafter listed as "KATANA-AIR").
03
Advertisement
Related Manuals for Roland KATANA-AIR
Summary of Contents for Roland KATANA-AIR
- Page 1 “Using BOSS TONE STUDIO for KATANA-AIR” PDF. * When using Android 6.0 or later, turn Location mode for the Android device on. * You can use BOSS TONE STUDIO for KATANA-AIR on both the KATANA-AIR and KATANA-AIR EX (hereafter listed as “KATANA-AIR”).
- Page 2 In your mobile device’s settings, turn Bluetooth on. NOTE Do not tap “KATANA-AIR MIDI” if it is shown in the Bluetooth settings of the mobile device. If you tapped this, temporarily cancel the device registration, and perform the procedure again...
- Page 3 * If you changed the Bluetooth ID (p.9), the changed number is shown following “KATANA-AIR MIDI”. * If more than one KATANA-AIR is detected as a connection point, a selection screen appears. * If the mobile device was already connected,...
- Page 4 If “Bluetooth Pairing Request” appears, tap “Pair”. The editor screen is shown once the connection is made.
- Page 5 When you turn the Bluetooth switch on in step 2, “KATANA-AIR MIDI” might appear in the list of “Available devices” but you should not tap it. If you tapped it, clear the pairing, and try the procedure...
- Page 6 Clearing the pairing Tap the gear icon shown beside “KATANA-AIR MIDI” in “Paired devices”, and tap “Unpair”. Turn the Bluetooth switch off. Turn Bluetooth on and off once again Turn Bluetooth on/off again.
- Page 7 Close all apps, and try the procedure again from step 1 (p.2) If you’ve checked – and still cannot connect to the app, close all apps that are running on your mobile device. If paired, remove the pairing. Closing the app Tap the Android multitasking button, and swipe right on the app screen.
- Page 8 If you’ve checked items – and still cannot connect to the app, turn off the mobile device and the KATANA-AIR, wait for about 10 seconds and power them on again. If paired, remove the pairing. If you’ve checked items –...
- Page 9 MEMO If you want to specify “2” as the Bluetooth ID, hold down the [CH B] button and press the KATANA-AIR unit’s [ Ā ] button. Long-press the KATANA-AIR unit’s [ Ā ] button to put the unit in standby mode.
- Page 10 If the setting was made correctly, the Bluetooth MIDI DEVICE screen of BOSS TONE STUDIO indicates “KATANA-AIR MIDI_1”. If, after specifying the number “1” or 2”, you want to return to a state in which nothing is specified, execute a factory reset (Owner’s Manual “Restoring the...