Setting The Remote Controller For Operation Of Your Tv - Panasonic NV-SD430 Series Operating Instructions Manual

Setting the Remote Controller for
Operation of your TV
You can operate the TVs of the manufacturers listed below This setting procedure allows you to operate the TVs of
with the remote controller after setting it. some manufacturerers using the supplied remote control
transmitter.
Set VCR/TV switch to TV for using POWER (5, the v :
and A buttons and the numeric buttons. Preparation i
Set the VCR/TV switch to TV.
Operations
ee )
1 Find the manufacturer number of your
TV while referring to the folllowing
table.
OPO SFFFFH207FTTFTHHOTHOEMROHHHLOSOHDO
Q
ma)
=
i
Y)
2 While holding down POWER (4, use
the numeric buttons to enter the
manufacturer number. This completes
the settings for the TV manufacturer.
© Be sure to enter the number in two digits.
Example: 101
bo SOR FOTOS HHOKFOH TH HHOHDDOHOEYD
3 To confirm that the correct settings
were made, check whether the TV can
be operated properly.
@ When a manufacturer has multiple numbers in :
the following table, try entering other numbers if
the TV operations cannot be performed properly,
and then select the optimal number,
ooo ee OGor oF GeO FHHOTRHAaRDKTARDHR AHR HH Ae 1
Notes:
© If you are using a Panasonic TV, this setting has already
been made, and so you do not need to perform the above
setting procedure. However, this remote controller may
not work with some Panasonic TVs.
i: . ® Some TV models cannot be operated using this remote
o1 Panasonic/ National controller (including all TVs non-remote compatible).
02 Panasonic/National
03 Panasonic/National
04 Panasonic/National
05 SONY
06 TOSHIBA
07 JVC
08 HITACHI
09 MITSUBISHI
10 MITSUBISHI
11. SHARP
12 PHILIPS, SAMSUNG
13 NEC
14 SANYO
15 GOLDSTAR
16 GOLDSTAR
17 SAMSUNG
18 SAMSUNG
12 SANYO