Table of Contents
Advertisement
17.
18.
19.
20.
21.
22.
23.
24.
25.
Monitor Hood Fixing Screws
These 2 screws are used to secure the monitor hood.
Monitor Fixing Screws
These 4 screws are used to secure the monitor.
The
tilt of the monitor can be changed approx. 30° by
loosing these screws.
Focus Control (FOCUS)
This control
is used
to adjust
the focus of the
monitor.
Camera Cable Connector (CAMERA)
This connector.
is used
to connect
the
optional
Camera
Cable
GP-CA40
(33 ft) or GP-CA41
(66
ft).
REMOTE
(9) +12V, 1.5A Input
6,®
Ground
Remote Input
(Reverse position —
+12V Input}
BOQ
OOO
DOOOODOO®
Monitor side
Camera Cable (Sold Separately)
Power
Source and Remote Connector
(REMOTE)
This 14-pin connector
is used to connect the sup-
plied power and Remote Cable.
Fuse Holder
Caution :
When
replacing
the
fuse,
use
only
specified one.
(3 Amp. Part No. YWTSC3A)
Monitor Fixing Plate
This is used to install the monitor to the car.
Fixing Holes
These 4 holes are used
to fix the monitor fixing
plate to the car.
INSTALLATION
8
Mounting the Camera onto the Top of Rear-end Roof
1. Connect
the camera
cable to the camera
cable con-
nector and secure the cable as shown below.
Secure the Cable
Connect Camera Cable
2. Secure the camera onto the rear-end of the roof using
4 bolts (prepared locally (6mm@ bolt)).
Rearview Camera
vehicle
Fix 4 Bolts
Note : Secure
the camera
so that the camera
posi-
tions
in parallel
with
the
rear-end
fine
of
vehicle.
1
Lww—— Center of vehicles width
Parallet
aralle
Rear of Vehicle
(Top View)
Caution : In case the camera touches to the roof of
vehicle,
slide
the camera
fixing plate as
shown below.
Approx, 18mm
Advertisement
Table of Contents
