Table of Contents
Advertisement
Set-Up Features
(cont.)
Located On Remote Control
Manual Prog
(Program)
- This feature allows
you to select which channels are placed into Channel
Scan Memory.
1.
Press the ACTION button to display the Main Menu.
2.
Press the CH UP/DOWN and VOL LEFT/RIGHT
buttons to highlight the Set Up Icon.
3.
Press the ACTION button to display the Set-Up
Menu.
Selects or Adjusts
Featureswhen
Menu is Displayed
Highlight Desired
Feature when
Menu is Displayed
[_ACTION
Displays and Exits Menus
Auto Prog
(Program)
- This feature allows you
to place all channels with a video signal into Channel
Scan Memory.
1.
Press the ACTION button to display the Main Menu.
2.
Press the CH UP/DOWN
and VOL LEFT/RIGHT
buttons to highlight the Set-Up Icon.
3.
Press the ACTION button to display the Set-Up
Menu.
4.
Press the CH DOWN button to highlight MANUAL
PROG.
5.
Press the VOL LEFT/RIGHT
button to display the
Manual Programming Menu.
4.
Press the CH DOWN button to highlight AUTO
PROG.
5.
Press the VOL LEFT/RIGHT
button to start Auto
Programming. Channels will automatically advance
until all channels have been scanned.
6.
Press the ACTION button twice after completion of
Auto Programming to exit the Set-Up Menu.
Note: Channels with signal present, will turn blue
when stored in Channel Scan Memory.
6.
Use the CH UP/DOWN
button or the numeric
keypad (0 through 9 buttons) to select channels.
7.
Press the VOL RIGHT button to add channel(s) to
memory (Blue). Press the VOL LEFT button to
delete channels from memory (Yellow).
8.
Repeat steps 6 and 7 to continue adding or deleting
channels.
9.
Press the ACTION button twice to exit the Manual
Programming Menus.
- 21 -
Advertisement
Table of Contents
