Advertisement
Available languages
Available languages
ENGLISH
10.
Rack
11.
Right burner
12.
Right control knob
13.
Left control knob
14.
Left burner
15.
Gas entry
For model USPAE3344(45)-23.
3 on page 5
16.
Cover
17.
Housing
18.
Rack
19.
Right burner
20.
Central burner
21.
Rigth control knob
22.
Central control knob
23.
Left control knob
24.
Non-stick base
25.
Left burner
26.
Gas entry
To see the characteristics of the product
you can see the table 01 on page 6.
ASSEMBLY AND INSTALLATION
This
product
does
complicated
installation
process.
Before
proceeding
product, memorize the position of every
accessory, in case you need to pack it up
again in the future.
Remove
material, labels and/or stickers
on the product. Make sure there
is no trace of the packaging
material in the burners or in the
grid, this could cause damages or fired
•
Inspect the product before using it. If
you think the product can be damaged,
please contact the selling point where
you acquired it.
•
Place the product on a flat surface
which is heat resistant.
•
Make sure there are no objects around
20
See imagen
not
require
any
or
assembly
to
unpacking
all
the
packaging
that could get burnt or be a potential
risk.
•
Install it outdoors, in a well ventilated
place.
•
Your product is prepared to work with
butane-propane. It is not suitable for
natural gas or city gas.
•
Connect the product to a butane or
propane gas bottle with a reducer
fitting and a flexible hose which are
certified.
•
Make sure the flexible hose is no longer
than 1,5 metres.
•
Do not twist the flexible hose.
•
Make sure that the flexible hose has
an expiry date and therefore it must be
replaced when suggested by that date.
Follow these steps to connect your product:
•
Put the rubber feet (in case they are
supplied disassembled) in the body of
the appliance.
•
Place the product over a surface so
that you have access to the inlet.
•
Connect the flexible gas hose, which
must previously be connected to the
gas bottle, to the inlet and fix it with a
clamp to prevent any gas leak.
•
Install the burners. First you must put
the gas hob burner crown, which must
be inserted in the tube and then the
flame cap cover.
the
•
Put the grid.
•
Make sure the knobs are in the off
position before you open the valve in
the gas bottle.
All this process must be carried
out with the gas bottle valve
closed to prevent any gas leak.
USING THE APPLIANCE
This device is easy to use and does not
require extensive knowledge. However,
it is a delicate product because it works
with gas, which is a power source that can
be dangerous. Please familiarize yourself
with your product before first use.
Advertisement
