Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
again.
• Press the buttom "Pulse/Clean" to clean
or use the turbo fuction.This function
only works if you keep pressing the
buttom.
• Press the buttom "Ice Crush" if you want
grind ice. This function star in the high
power and them decreise the power
• It is recommended to use this function
in intermittent mode in order to not
overheat the motor. If you wish to
deactivate this function, press the
button again.
• After you finish use it you should power
off and clean the appliance.
BASIC KNOWLANGE OF THE
PRODUCT:
• The blender will stop working after 60
seconds when the maximum speed is
used continuously.
• The speed of the machine's motor is
fast, and single use should not exceed
3 minutes. Do not use it for a long time,
and pay attention to safety.
• Please do not introduce food or liquids
with a high temperatura because the
jug can broke it.
• To crush the ice use the moode "Ice
Crush" in short intervals of time
• When there is no liquid in the jug and
food such as dried chickpeas, nuts, etc..
Use a wooden or plastic spatula to push
the products that remain stuck to the
walls of the jug.
NEVER USE THE
SPATULA WHEN THE
PRODUCT IS ON
BECAUSE YOU CAN
SUFFER AN ACCIDENT
IF YOU HAVE SEVERAL
MOUNTH
THE
SUGGEST
16
NOT
USING
PRODUCT.WE
USE
IT
IN
SECTIONS OF TIME OF 1 MINUTE.
CLEANING AND MAINTENANCE
• Be sure to unplug the power plug before
cleaning the product.
• Clean
the
immediately after use.
• The outside of the motor base can be
wiped with a wet cloth.
• After use and the idle time is more than
10 minutes each time, please clean the
blade base in time.
• Before storing the product, make sure it
is clean and dry.
• If it is not used for a long time, please
unplug the power plug from the socket
and pay attention to the dust and insect
protection of the body.
• Firsly fill 2/3 of the jug (not hot) and a
little bit of soap .Them press the buttom
"Pulse/Clean" for 30seconds
• Get out all the dirty water then rinse the
jug with clean water and let it dry..If is
not clean repeat the process.
• The base of the
disassembled. Two people are needed
to carry out the following steps:
• One person should hold the body of the
blendeer.
• The other person need to twist to the
left the jug
• And to reassamble make sure to put
well all rhe parts to avoid leaks
• It is not recommended to disassemble
the
base
watertightness problems. Remove it
only when strictly necessary.
• It is not recommended to unscrew
the blade from its base, as this may
cause leaks if it is not fitted correctly
afterwards. If necessary, turn the screw
on the base counterclockwise and
remove the blades with the seal facing
upwards.
• Now clean the jug, lid, seal, base and
blades with hot water and a little
cleaning agent. Dry thoroughly before
using
• it again. Be careful, the blades inside
product
and
blades can be
frequently
due
parts
to
Advertisement
Table of Contents
