Display And Control Panel Triggering Device - Protronic RZ3 Operating Manual

Operating Manual RZ3/4

7.6. Display and control panel Triggering device

1 4
2 5
3 6
Figure 5 - Release device
The "Triggering device" display and control panel contains the following optical signals (LED)
and buttons:
" " - Closing - optical signal and control element (1)
Button - manual closing initiates controlled closing process without activating emergency power.
LED closing lights up during the closing process.
 Remote closing - optical signal (2)
LED " " - remote closing indicates active closing command by remote control (e.g. by conveyor
control or actuation of the remote pushbutton)
" " - Open - control element (3)
Button - Open resets manual closing and starts the opening procedure.
Triggering - optical signal (4)
LED Triggering lights up in case of: Fire alarm, short circuit or interruption of the fire alarm loop.
The "Test" button has been pressed.
Operation - optical signal (5)
LED -operation lights up when the voltage supply of the controller unit is switched on.
Fault - optical signal (6)
LED "!" -fault indicates general error of the CPU.
Page 17 of 32 Protronic Innovative Steuerungselektronik GmbH
Grimmaische Str. 92, D-04828 Bennewitz, district Pausitz