Table of Contents
Advertisement
2. B-Y signal (TP238)
With [VOLUME+/-] buttons of the remote control transmitter, adjust the value appearing below B-Y indication so that the
amplitude (white-blue) at TP238 becomes 0±0.03V.
3. R-Y signal (TP236)
With [VOLUME+/-] buttons of the remote control transmitter, adjust the value appearing below R-Y indication so that the
amplitude (white-red) at TP236 becomes 0±0.03V.
8.5.
Flicker Adjustment
1. Enter the adjustment mode and select the " FLICKR".
2. Adjust the Flicker Adjustment until the flicker displayed on the screen is minimum.
Note:
Adjustment shall be done after it is made to overrun value of adjustment once as shown figure A.
Note:
Make the adjustment to look for the optimum point because the level of flicker doesn´t disappear on the screen completely as
shown figure A.
Figure A
19
CT-L1400
Advertisement
Table of Contents
