Mitsubishi Electric CITY MULTI PLFY Series Technical & Service Manual page 43

11-5-2. PAR-SL101A-E
Fig. 11-1
Fig. 11-2
Fig. 11-3
Fig. 11-4
TCH123
1. Going to the function select mode
Press the
(Start this operation from the status of remote controller display turned off.)
[CHECK] is lit and ˝00˝ blinks. (Fig. 11-1)
button to set the ˝50˝.
Press the
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
2. Setting the unit number
button to set unit number A. (Fig. 11-2)
Press the
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
A
3. Select a mode
button to set Mode number B. (Fig. 11-3)
Press the
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
Current setting number:
B
4. Selecting the setting number
button to change the Setting number C. (Fig. 11-4)
Use the
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
5. To select multiple functions continuously
Repeat select 3 and 4 to change multiple function settings continuously.
6. Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit
C
and press the
Note:
Make the above settings on Indoor units as necessary.
• Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
button between of 5 seconds.
button.
button.
button.
1=1 beep (1 second)
2=2 beep (1 second each)
3=3 beep (1 second each)
button.
button.
43