Sharp LC-32AX5H Service Manual page 19

4. Public Mode Menu
The guidance is not displayed onscreen.
Setup procedure
• To move the cursor up and down, use the "cursor UP/DOWN" key (remote controller) and "CH (
• To change the settings, use the "cursor RIGHT/LEFT" key (remote controller) and "VOL (+)/(–)" key (remote controller and set).
• To save new settings, keep the cursor at "Enter" and use the "cursor RIGHT/LEFT" key (remote controller) and "VOL (+)/(–)" key (remote controller
and set).
Public mode
Power on fixed [Variable
Maximum volume [
Volume fixed [Variable
Volume fixed level [
RC button [Respond
Panel button [Respond
Menu button [Respond
On screen display [Yes
Input mode start [Normal
Input mode fixed [Variable
232C Powon [Disable
RC path through [Off
Reset
Enter
5. On Setting Items
1. POWER ON FIXED
Selection Variable/Fixed
Default Variable
Explanation When set to "Fixed", the power cannot be turned off with the power key on the remote control or main unit, and the image
reception state is kept (it does not enter the standby state).
The power can be turned off by shutting off power supply from AC.
Limit in setting • Power key on the main unit/remote control power supply key
• OFF timer/ON timer
Exception None
Remarks • Selection of "FIXED" assumes use of STB, etc.
• When set to "Variable", if the main power switch is set to off, the power is turned off after a wait of 1 second.
(Push-push switch only)
• Display ON/OFF in the hotel menu is controlled by the adjustment process "HOTEL POWERFIX".
• When the power button is operated, a caution is displayed (it times out in 5 seconds).
(For the caution, refer to the power on fixed message sheet.)
* The caution is not displayed when in the adjustment process, hotel menu, default setting, MCL operation and auto preset
(Ch search operation).
The OSD display including the menu and this caution have priority over all others.
When "OSD display" (described below) is set to "Variable", this caution is displayed as a special case.
2. MAXIMUM VOLUME
Selection Adjustment from 1 to 60 (no loop)
Default 60
Explanation Sound volume can not be adjusted higher than the preset value.
Limit in setting • When the sound volume is set lower than 59, only figures are displayed and the sound volume bar is not displayed.
• The maximum sound volume for ON-timer (Wake up timer) is limited also to the preset value.
Exception • In the item "VOLUME" of adjustment process, the sound volume can be set freely irrespective of this setting.
Remarks • Setting is valid only for the speakers of the unit. (As for the headphone, the sound volume can be set up to 60 irrespective
of the limit.)
• In line output (sound volume variable), the sound volume can be adjusted from -60 to 0 irrespective of pre-adjusted value.
• When the sound volume is set higher than the MAX setting by the adjusting process or headphone, the sound volume con-
trol operation is prohibited for turn-up and the sound volume should be turned down to MAX in this state.
]
60]
]
20]
]
]
]
]
]
]
]
]
)/(
5 – 7
LC-32AX5H/M/X
)" key (remote controller and set).